Need help?Do you have a question about the SMA SUNNY ISLAND 6.0H and is the answer not in the manual?
General| Rated Power | 6000 W |
|---|---|
| Maximum AC Power | 6000 W |
| AC nominal voltage | 230 V |
| AC grid frequency | 50 Hz / 60 Hz |
| DC voltage range | 40 - 60 V |
| Max. Efficiency | 96 % |
| Operating Temperature Range | -25 °C to +60 °C |
| Protection class | IP 54 |
| Cooling | Natural convection |
| Model | SUNNY ISLAND 6.0H |
| Max. apparent AC power | 6000 VA |
| AC voltage range | 184 V - 265 V |
Defines appropriate and inappropriate uses of the Sunny Island and Remote Control.
General safety precautions to prevent injury and damage.
Explains dangers from electric shock due to damaged Sunny Island.
Explains dangers from explosive gases from batteries and prevention.
Explains hazards of battery electrolytes and necessary protective measures.
Explains hazards of short-circuit currents in batteries and safety precautions.
Explains hazards of generator parts and safety advice.
Explains risks of touching hot components of the Sunny Island.
Explains how incorrect parameter settings can damage the battery.
Procedure for switching on the Sunny Island unit.
Steps to start the overall system operation.
Procedure for stopping the system and putting it into standby mode.
Steps to completely switch off the Sunny Island.
How to activate emergency disconnection and its effects.
How to configure time-controlled inverter operation.
How to display, operate, and set system parameters in user mode.
Steps to access installer and expert modes.
Procedures for exiting installer and expert modes.
How to navigate and select menus and parameters.
Step-by-step guide to setting parameters in installer mode.
Method for accessing parameters using a five-digit number.
How to save and load parameter sets using the SD card.
Steps to update firmware via SD card.
How to update firmware using Sunny Explorer software.
Procedure for remote firmware updates via Sunny Portal.
How to start the generator using the remote control.
How to stop the generator using the remote control.
Risks of ESD and prevention measures.
Explains how the system behaves under fault conditions.
Steps to acknowledge errors after resolving the cause.
Details warnings and errors for the Sunny Island master.
Details overvoltage and overfrequency errors.
Details derate errors related to temperature.
Details undervoltage and undesired voltage errors.
Details overcurrent and overload errors.
Details battery voltage and temperature errors.
Details battery voltage and temperature warnings.
Details relay and external voltage/frequency errors.
Details external frequency and stand-alone grid errors.
Details voltage rise and short circuit errors.
Details AC phase mismatch and tie switch errors.
Details generator and generator start errors.
Details utility grid current and relay errors.
Details battery voltage and sensor errors.
Details communication and cable errors.
Details multicluster box and system errors.
Details multicluster box contactor and communication errors.
Details charger communication and battery errors.
Details charger 2 communication and battery errors.
Details charger 3 communication and battery errors.
Details charger 4 communication and battery errors.
Procedure for charging the battery after automatic shutdown.
How to connect the generator for charging.
Steps for charging the battery in emergency mode.
Procedure for disconnecting the generator.
Procedure to change slave addresses in a cluster.
Steps to change slave addresses using the remote control.
Steps for checking and maintaining the battery.
Safety warnings and procedures for replacing the battery.
Detailed procedure for replacing the battery and configuring new settings.
To Next Page
