SMA SUNNY ISLAND 6.0H - Starting and Stopping the System; Switching on the Sunny Island; Starting the System

SMA Solar Technology AG 4 Starting and Stopping the System
Operating Manual SI60H-80H-BE-en-20 17
4 Starting and Stopping the System
4.1 Switching on the Sunny Island
Requirements:
☐ The load-break switch in the DC cable must be closed.
☐ The Sunny Island must not have switched itself off (see Section9.6 "Charging the Battery after Automatic Shutdown
in Off-Grid Systems", page69).
Procedure:
• For systems with one Sunny Island, press the "On" button on the
Sunny Island.
• For systems with up to three Sunny Island inverters, press and hold
the "On" button on the master until an acoustic signal sounds.
• For multicluster systems, press and hold the "On" button on each
master until an acoustic signal sounds.
☑ The inverter LED on each Sunny Island is glowing orange and the Sunny Island inverters are in standby mode.
4.2 Starting the System
Requirement:
☐ All Sunny Island inverters must be switched on.
Procedure:
• Press and hold the Sunny Island start-stop button until and acoustic
signal sounds.
or
Press and hold the button on the Sunny Remote Control until an acoustic signal sounds.
☑ The inverter LED on each Sunny Island is glowing green.