SMA SUNNY ISLAND 6.0H - Setting the Parameters

5 Operating the Sunny Island via Sunny Remote Control SMA Solar Technology AG
30 SI60H-80H-BE-en-20 Operating Manual
7. To exit the parameter page, switch to the higher level or switch to standard mode:
• Turn the button to the left until the return symbol appears in the first line.
• To switch to a higher menu level, turn the button to the left until <back> appears.
• To switch to standard mode, turn the button to the left until <home> appears.
• Press the button.
Tip: <back> and <home> also appear at the end of the list if the button is turned to the right.
5.4.6 Setting the Parameters
1. Switch to installer mode on the Sunny Remote Control (see Section5.4.1, page28).
2. Select the desired parameter. You can only set the parameters for
which < Set > is shown in the second line in the display.
3. Press the button.
☑ The return symbol flashes next to the value.
✖ Stop device to change the value? appears in the display.
The parameter can only be changed in standby mode.
• Stop the system (see Section4.3, page18).
✖ No permission to change the value appears in the display.
You are not allowed to change the parameter in installer mode.
• If you want to change the parameters for the battery, select the menu New Battery in the QCG (see
Section10.8 "Replacing the Battery", page77).
• For all other settings in the QCG, select the menu New System (see the installation manual of the Sunny
Island).
4. To set the parameter, turn the button to the left or right.
5. Press the button.
☑ The Sunny Remote Control requests a confirmation of the set
parameter.
6. To confirm the value, turn the button to the right until Y flashes and
then press the button.
7. To discard the value, turn the button to the right until N flashes and then press the button.