SMA SUNNY ISLAND 6.0H - Sunny Remote Control

3 Product Description SMA Solar Technology AG
16 SI60H-80H-BE-en-20 Operating Manual
3.4 Sunny Remote Control
You can configure and control the system from a central location using the Sunny Remote Control display.
Figure3: Layout of the Sunny Remote Control
Service Interface SD Memory Card
The Sunny Remote Control has a slot for SD memory cards. The SD memory card stores data for system control and
facilitates service work. You can also update the firmware of the Sunny Island using the SD memory card. The following
data is stored on the SD memory card:
• Parameter settings
• Every minute, measurement data from the areas:
– Battery
– Sunny Island
– Generator
– Utility grid
– Stand-alone grid
• Events and errors
• Statistical values of the battery
The SD memory card must be formatted as FAT-12 or FAT-16. SD memory cards with a memory capacity of more than
2 GB are not supported.
Position Designation Explanation
A Display Four-line display shows operating data (e.g. operating state, display values) and events,
warnings or errors of the Sunny Island.
The display backlight is automatically deactivated after a short time of inactivity.
B Button Pressing the button will turn on the backlight, confirm parameters or switch the level
within a menu. The return symbol " " in the display indicates when you can perform
an action by pressing the button.
Turning the button will switch on the backlight, change parameters or navigate within a
menu level.
C Slot for the SD
memory card
‒