SMA SUNNY ISLAND 6.0H - Directly Accessing Parameters

SMA Solar Technology AG 5 Operating the Sunny Island via Sunny Remote Control
Operating Manual SI60H-80H-BE-en-20 31
5.4.7 Directly Accessing the Parameters
Any parameter can be accessed directly by entering a five-digit number. The five-digit number is composed as follows:
• The first three digits are the menu number.
• The last two digits are the parameter number.
Procedure:
1. Switch to installer mode on the Sunny Remote Control (see Section5.4.1, page28).
2. Select the parameter 600.02 Select Number and set the five-digit number.
☑ The parameter is displayed.
✖ The display shows Item not Found?
You cannot access the parameter in installer mode.
• Press the button and switch to expert mode (see Section5.4.1, page28).
The number set is incorrect.
• Press the button and enter the number again.
Example: Five-digit number for direct parameter access.
You want to use parameter 111.01 TotInvPwrAt to show the entire active power of the Sunny Island in a cluster. The
five-digit number for direct access is 11101.