SMA SUNNY ISLAND 6.0H - 1 Information on this Document

SMA Solar Technology AG 1 Information on this Document
Operating Manual SI60H-80H-BE-en-20 7
1 Information on this Document
Validity
This document is valid for the following device types:
• SI8.0H-11 (Sunny Island 8.0H) from firmware version 3.0
• SI6.0H-11 (Sunny Island 6.0H) from firmware version 3.0
• SRC-20 (Sunny Remote Control)
Target Group
This document is intended for qualified persons and operators. Only persons with the appropriate skills are allowed to
perform the tasks described in this document (see Section2.2 "Skills of the Target Group", page10). Some tasks may
only be performed by qualified persons and are labeled with a warning symbol and the designation "Qualified Person".
Tasks that can be performed by operators and qualified persons are not labeled and may also be performed by
operators.
Symbols
Typographies
Symbol Explanation
'$1*(5
Indicates a hazardous situation which, if not avoided, will result in death or serious injury
:$51,1*
Indicates a hazardous situation which, if not avoided, can result in death or serious injury
&$87,21
Indicates a hazardous situation which, if not avoided, can result in minor or moderate injury
/05*$&
Indicates a situation which, if not avoided, can result in property damage
Indicates that the following section contains tasks that may only be performed by qualified
persons
Information that is important for a specific topic or goal, but is not safety-relevant
☐ Indicates a requirement for meeting a specific goal
☑ Desired result
✖ A problem that might occur
Typography Usage Example
bold • Display messages
• Parameters
•Terminals
•Slots
• Elements to be selected or
entered
• Connect PE to AC2Gen/Grid.
• Select the parameter 235.01 GnAutoEna
and set to Off.
> • Connects several elements to be
selected
•Select 600# Direct Access > Select
Number.