13 Directory of the Parameters in Installer Mode and Expert Mode SMA Solar Technology AG
90 SI60H-80H-BE-en-20 Operating Manual
13.1.3 External (130#)
131# Total
132# Grid State
120.08 RmgTmFul Remaining time until next full charge in days ‒ ‒
120.09 RmgTmEqu Remaining time until next equalization charge
in days
‒‒
120.10 AptPhs Status of the absorption phase Off (1) Absorption phase
not active
On (2) Absorption phase is
active
120.11 BatSocErr Estimated error of the state of charge (SOC) in %
(expert mode)
‒‒
120.12 BatCpyThrpCnt Nominal energy throughputs of the battery
A nominal energy throughput is the calculated
result of one full charge and discharge of the
battery.
‒‒
No. Name Description
131.01 TotExtPwrAt Total active power of external energy source inkW
131.02 TotExtCur Total current of external energy source in A
131.03 TotExtPwrRt Total reactive power of the external energy source in kvar
No. Name Description Value (plain
text no.)
Explanation
132.01 GdStt Status of the management for
the operation on the utility grid
(expert mode)
Off (1) Grid operation is disabled.
Init (2) Utility grid has been detected.
Detect (3) Grid monitoring started.
Wait (4) Waiting until the stand-alone grid is
synchronized with the utility grid.
RunVExt (5) The stand-alone grid is synchronized with
and connected to the utility grid.
Feed (6) Grid feed-in into the utility grid is possible.
Silent (7) Sunny Island is in silent mode.
SiStr (8) The Sunny Island is switching to silent mode.
SiStp (9) The Sunny Island is leaving silent mode.
Error (10) An error occurred when connecting.
Reinit (11) Utility grid has been re-detected.
132.02 GdRmgTm Remaining time of grid
monitoring in hh:mm:ss
‒‒
No. Name Description Value (plain
text no.)
Explanation
To Next Page
Loading...
