SMA Solar Technology AG Mounting the Device
Installation Guide WB33_38-IEN101830 19
6. Secure the inverter in position by screwing the
supplied M6 contact screw, located on the
underside of the enclosure. Use the contact
washers provided with the toothing against the
enclosure. Tighten the screw with a torque
ofapprox. 5Nm.
7. Check to ensure that the inverter is firmly fastened. The wall mounting bracket is designed so
that the inverter tilts backward slightly on a perfectly vertical wall.
8. Attach the air grills provided to the inverter. To help
you identify the sides, "links/left" or "rechts/right" is
printed on the inside of the air grids.
☑ The inverter is now mounted.
To Next Page
Loading...
