SMA Solar Technology AG Electrical Connection
Installation Guide WB33_38-IEN101830 29
5.5.2 Assembling the PV connector
The connection cables of the small wind turbine system must be equipped with the PV connectors
provided for connecting the inverter.
To assemble the PV connectors, proceed as detailed below. Ensure the plug connectors have the
correct polarity. The PV connectors have the symbols "+" and " − ".
Cable Requirements
• Use a PV1-F cable.
Procedure
1. Insert stripped cable into the plug as far as it will go.
2. Press the clamping clip down until it audibly snaps
into place.
3. Ensure the cable is correctly in place.
Result Action
☑ If the conductors are visible in the hollow
cavity of the clamping clip, the cable is in
the correct position.
• Proceed to step 4.
To Next Page
Loading...
