X
Turn bulb holder : anti-clockwise and
remove.
X
Take the bulb out of bulb holder :.
X
Insert the new bulb into bulb holder :.
X
Insert bulb holder : and turn it clock-
wise until it engages.
X
To fit the cover in the front wheel arch:
insert cover ; again and lock in place.
Dipped-beam/main-beam headlamps
X
Switch off the lights.
X
Open the service cover (Y page 216)
.
X
Remove cover :.
X
Pull out the connector.
X
Simultaneously press retainer ;
forward
and
to the right and then remove
the lamp.
X
Insert the new bulb and engage it in
place.
X
Insert the connector.
X
Position cover : and press into place.
Front foglamps
Due to their location, have the bulbs in the
front foglamps
changed at a qualified spe-
cialist workshop.
X
Switch off the lights.
X
Remove the two screws : at the bottom of
the front wheel arch using a suitable
tool.
X
Bend back the cover using your hand.
X
Turn the bulb holder anti-clockwise and
remove it.
X
Take the bulb out of the bulb holder.
X
Insert the new bulb into the bulb holder.
X
Insert the bulb holder and turn it clock-
wise until it engages.
X
Bend the cover back into position.
X
Tighten the two screws : again.
Side turn signal lamps
Replacing bulbs
99
>> Lights and windscreen wipers.
Z