SMART forfour - Headlamp Flasher

g
Driver's seat is occupied or driver's
seat and
front-passenger seat are occu-
pied
1
All seats are occupied
2
All seats are occupied and luggage
compartment laden
3
Driver's seat is occupied and luggage
compartment is laden
4
This setting is not required
X
Turn the key to position 2 in
the ignition
lock or start the engine.
X
Turn headlamp range control : to the
position which corresponds to the load
in your vehicle.
Switching on the turn signals
X
Start the engine.
X
To indicate briefly: press the combina-
tion switch briefly to the pressure point
in the direction of arrow : (right turn
signal) or ; (left turn signal).
The corresponding turn signal flashes
three times.
X
To indicate: press the combination
switch beyond the pressure point in the
direction
of
arrow : (right turn signal)
or ; (left turn signal).
Switching on the main-beam headlamps
and headlamp flasher
Main-beam headlamps
X
To switch on: start the engine.
X
Turn the combination switch control
until K or à (if available) is at
the marking.
X
Press the combination switch beyond the
pressure point in the direction of
arrow :.
The K indicator lamp in the instru-
ment cluster lights up.
X
To deactivate: move combination
switch : back to its normal position.
The K indicator lamp in the instru-
ment cluster goes out.
Headlamp flasher
X
To switch on: pull the combination
switch in the direction of arrow ;.
Exterior lighting
95
>> Lights and windscreen wipers.
Z