SMART forfour - Introduction

X
Press release button :, hold belt
tongue ; and
guide it back towards belt
outlet =.
Belt warning for the driver and front
passenger
The 7 seat belt warning lamp in the
instrument cluster is a reminder that all
vehicle occupants must wear their seat
belts. It
may light up continuously or flash.
In addition, a warning tone may sound.
The 7 seat belt warning lamp goes out
and the warning tone ceases when the driver
and the front passenger have fastened their
seat belt.
Rear seat belt status indicator
With the status indicator for the rear-com-
partment seat belts you can determine
which rear seat belt is not fastened.
Seat belt warning lamp : and rear seat
belt status indicator ; and = light up
when
the
ignition is switched on. When you
drive off and have reached a speed of
approximately 10 km/h the lamps go out
after approximately 30 seconds. When a
door is opened, the lamps light up again.
Rear seat belt status indicator ; and =
inform you about the status of the seat
belts. They always light up simultaneously,
the status is indicated by the colour.
R
Red: seat belt not fastened.
R
Green: seat belt fastened.
Indicator ; shows the status of the left
rear seat, for example.
Seat belt warning lamp : and rear seat
belt status indicator ; and = light up
when:
R
you drive off and do not exceed a speed of
approximately 20 km/h
and
R
the rear passengers fasten or unfasten
their seat belts while the vehicle is in
motion.
If you drive off and a rear seat belt is
unfastened after the vehicle exceeds a
speed of about 20 km/h:
R
seat belt warning lamp : flashes
R
rear seat belt status indicator ; and/or
= lights up red
R
a tone sounds
A rear seat does not have to be occupied.
Airbags
Introduction
The installation location of an airbag is
identified by the AIRBAG symbol.
An airbag supplements a correctly worn
seat belt. It is not a replacement for the
Occupant safety
43
>> Safety.
Z