Excessive levels of electromagnetic radi-
ation may cause damage to your health and
to the health of others. The use of an exte-
rior aerial takes into consideration the
scientific discussion surrounding the
possible health
risk posed by electromag-
netic fields.
The following aerial positions may be used
if RF transmitters have been properly
installed:
Approved aerial positions
:
Front roof area
;
Rear roof area
i
On vehicles with a folding top, fitting
an aerial to the front roof area is not
permitted.
Use Technical Specification ISO/TS 21609
(Road Vehicles – "EMC guidelines for fit-
ting aftermarket radio frequency trans-
mitting equipment") when retrofitting RF
(radio frequency) transmitters. Comply
with the legal requirements for add-on
parts.
If your vehicle has fittings for two-way
radio equipment, use the power supply or
aerial connections intended for use with
the basic wiring. Be sure to observe the
manufacturer's additional instructions
when installing.
Deviations with respect to wavebands,
maximum transmission outputs or aerial
positions must be approved by Mercedes-
Benz.
The maximum transmission output (PEAK) at
the base of the aerial must not exceed the
following values:
Waveband Maximum
transmission
output
Tetra
380 - 410 MHz
20 W
Mobile communica-
tions generation
2G/3G/4G
6 W
The following can be used in the vehicle
without restrictions:
R
RF transmitters with a maximum trans-
mission output of up to 100 mW
R
Mobile phones (2G/3G/4G)
There
are no restrictions when positioning
the aerial on the outside of the vehicle for
the following wavebands:
R
Tetra
R
Mobile communications (2G/3G/4G)
Identification plates
Vehicle identification plate with
vehicle identification number (VIN)
X
Open the front right-hand door.
You will see vehicle identification
plate :.
Identification plates
267
>> Technical data.
Z
To Next Page
Loading...
