SMART forfour - Page 160

F
eco score display (Y page 140)
Reserve fuel display (Y page 155)
G
b Brake lamp failure warning lamp
(Y page 168)
H
Total distance recorder
I
V Cruise control (Y page 145)
È Limiter
Menus and multi-displays
Overview
The arrangement
of the menus and displays
can be envisaged as a circle.
X
To scroll: repeatedly press the ´
but-
ton on the multifunction lever.
The menu functions/displays are shown
one after the other.
i
If the ´ button is pressed and held
for approximately 3 seconds, the trip
meter appears directly on the display.
Depending on the vehicle equipment, you
can call up the following menus/displays
one after the other:
R
display and reset the trip meter
(Y page 158)
R
display the current fuel consumption
(Y page 158)
R
display the service due date
(Y page 218)
R
set the time menu (Y page 158)
R
restart the tyre pressure monitor
(Y page 254)
Resetting values
You can reset the trip meter data and the
eco score display (Y page 140). You can only
reset the eco score if the display is show-
ing the current fuel consumption.
X
Repeatedly press the ´ button on the
multifunction lever until the display
shows the trip meter data or the current
fuel consumption.
X
Press and hold the b button on the
multifunction lever.
The trip meter value or the eco score
display flashes for approx.
3 seconds
.
The data is then reset.
The count in the eco score display only
reappears once a distance of approx.
400 m has been covered. If the ignition
remains switched off for longer than four
hours, the eco score display in the on-
board computer will be automatically
reset.
X
When the value has been reset, release
the b button.
If you release the b button earlier,
the data shown will not change.
Current fuel consumption
When the vehicle is stationary or up to a
speed
of
approximately 5 km/h, the display
shows the current fuel consumption as a
numeric value in l/h.
Setting the time
X
Repeatedly press the ´ button on the
multifunction lever until the display
shows the ° symbol alongside the
time.
X
Press and hold the b button on the
multifunction lever until the hour value
flashes.
X
Press ´ to set the hour and confirm
the selection with b.
The minute value flashes.
X
Press ´ to set the minutes and b
to
confirm the selection.
The display will show the time selected.
i
If the ´ button on the multifunction
lever is pressed and held when setting
the time, the numerical values will
change continuously.
158
Displays and operation
>> On-board computer and displays.