EasyManua.ls Logo

SMART forfour - Page 234

SMART forfour
280 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
You should therefore adapt your driving
style accordingly and drive carefully. Do
not exceed the specified maximum speed
with a tyre that has been repaired using
tyre sealant.
The maximum speed for a tyre sealed with
tyre sealant is 80 km/h. The
80 km/h maxi-
mum speed sticker must be affixed to the
instrument cluster within the driver's
field of vision.
!
After use, excess tyre sealant may run
out of the filler hose. This could cause
stains.
Therefore, place the filler hose in the
plastic bag that contained the TIREFIT
kit.
H
Environmental note
Have the used tyre sealant bottle disposed
of professionally, e.g. at a qualified spe-
cialist workshop.
If
a
tyre pressure of 180 kPa (1.8 bar/26 psi)
has been achieved after 10 minutes:
X
Switch off the tyre inflation compressor.
X
Unscrew the filler hose from the valve of
the defective tyre.
X
Stow the tyre sealant bottle, the tyre
inflation compressor and the warning
triangle.
X
Pull away immediately.
X
Stop after driving for approximately
3
km and check the tyre pressure with the
tyre inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
G
WARNING
If the required tyre pressure is not reached
after
driving
for a short period, the tyre is
too badly damaged. The tyre sealant cannot
repair the tyre in this instance. Damaged
tyres and a tyre pressure that is too low can
significantly impair the vehicle's braking
and driving characteristics. There is a
risk of accident.
Do not continue driving. Contact a quali-
fied specialist workshop.
X
Correct the tyre pressure if it is still at
least 130 kPa
(1.3 bar/19 psi). For values,
see the tyre pressure information label
on the driver's side B-pillar.
X
To increase the tyre pressure: switch on
the tyre inflation compressor.
X
To reduce the tyre pressure: depress
pressure
release
button : next to pres-
sure gauge ;.
X
If the tyre pressure is correct, unscrew
the filler hose from the valve of the
sealed tyre.
X
Screw the valve cap onto the valve of the
sealed tyre.
X
Drive to the nearest qualified specialist
workshop and have the tyre changed
there.
X
Have the tyre sealant bottle and the
filler hose replaced as soon as possible
at a qualified specialist workshop.
X
Have the tyre sealant bottle replaced
every four years at a qualified special-
ist workshop.
232
Flat tyres
>> Breakdown assistance.

Table of Contents

Other manuals for SMART forfour

Related product manuals