Connect the outlet pipes according to the marking on the pipes.
CAUTION
IF THERE ARE UNUSED OUTLETS, SEAL THEM WITH
A 1/2” MALE PLUGS AND RECONFIGURE THE
OUTLETS’ CONFUGURATION FROM THE
APPLICATION (SEE SECTION “SOFTWARE OUTLETS
CONFIGURATION”)
BY DEFAULT, THE DIVERTING FUNCTION OF E-
VALVE WILL CYCLE THE OUTLETS IN THE
FOLLOWING ORDER: OUT1 OUT2 OUT3. OUT1
IS THE DEFAULT OUTLET. CONNECT THE
DIFFERENT OUTLETS ACCORDINGLY.
MAKE SURE THAT THE PIPEWORK IS
PERPENDICULAR TO THE E-VALVE SO THAT THERE
IS NO STRAIN ON THE FITTINGS.
To Next Page
Loading...