SmarTap e-Valve - Page 7

5 of 51
Installation Guidelines
CAUTION
THE E-VALVE SHOULD BE INSTALLED IN AN
ACCESSIBLE LOCATION FOR MAINTENANCE (AND NO
WARRANTY CLAIM CAN BE CONSIDERED OR
LIABILITY ACCEPTED BY SMARTAP IF LACK OF
ACCESSIBILITY HAS PREVENTED MAINTENANCE).
CAUTION
THE E-VALVE MUST NOT BE INSTALLED IN PLACES
WHERE EITHER THE AMBIENT TEMPERATURE IS
LIKELY TO EXCEED 40°C OR WHERE FREEZING MAY
OCCUR.
THE DIAL CONTROLS MUST NOT BE INSTALLED IN
PLACES WHERE THE AMBIENT TEMPERATURE IS
LIKELY TO FALL BELOW 5°C OR RISE ABOVE 60°C.
CAUTION
TO PREVENT DAMAGE IN THE EXISTING
INFRASTRUCTURE IT IS MOST RECOMMENDED TO
CHECK FOR HIDDEN PIPES OR CABLES BEFORE
DRILLING ANY HOLES.
PIPES ON BOTH INLET AND OUTLETS SHOULD BE AS
SHORT AS POSSIBLE IN ORDER TO AVOID
REDUCTION OF FLOW RATE AT THE CONNECTED
OUTLETS.