smartheart 01-508 - ELECTROMAGNETIC COMPATIBILITY; Guidance and manufactures declaration - electromagnetic emissions

ENGLISH • 27
ELECTROMAGNETIC COMPATIBILITY
Table 1
For all ME EQUIPMENT and ME SYSTEMS
1)This product needs special precautions regarding EMC and needs to be installed and put into service according to the EMC
information provided, and this unit can be affected by portable and mobile RF communications equipment.
2)* Do not use a mobile phone or other devices that emit electromagnetic elds, near the unit. This may result in incorrect
operation of the unit.
3)Caution: This unit has been thoroughly tested and inspected to assure proper performance and operation!
4)* Caution: This machine should not be used adjacent to or stacked with other equipment and that if adjacent or stacked
use is necessary, this machine should be observed to verify normal operation in the conguration in which it will be used.
Emissions Test Compliance Electromagnetic Environment Guidance
Group 1
Class B
Class A
Compiles
The device uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
The device is suitable for use in all establishments, other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
RF emissions
CISPR11
RF emissions
CISPR11
Harmonic distortion
IEC 61000-3-2
Voltage uctuations /
icker emissions
IEC 61000-3-3
Guidance and manufacture’s declaration - electromagnetic emissions
The device is intended for use in the electromagnetic environment specied below. The customer or the user of the device
should assure that it is used in such an environment.