Drive Startup Manual HPV900-Induction
Page 2 © 2020 Smartrise Engineering, Inc. All Rights Reserved March 5, 2020
Equipment/Settings Verification
Set and verify the equipment matches the job specific parameters for proper operation. See C4
Controller sheet 01 Getting Started Parameter Table for more information.
Figure 2: Example of Parameter Table
Magnetek Parameter Location Reference
Adjust A0
Drive A1
• Encoder Pulses (Encoder PPR – 1024/2048)
Power Convert – A4
• Input L-L Volts
Motor – A5
• Rated Mtr Power (Kw)
• Rated Mtr Volts (VAC)
• Rated Exit Freq (60Hz)
• Rated Motor Curr (FLA – Amps)
• Motor Poles
• Rated Mtr Speed (RPM)
Configure C0
User Switches – C1
• Motor Rotation
• Forward/Reverse
• Encoder Connect
• Forward/Reverse
To Next Page
Loading...