Status Information
5-87
5
CLI Commands for Displaying System Settings – To view the current access point
system settings, use the show system command from the Exec mode. To view the
current radio interface settings, use the show interface wireless g 0 command
(see page 6-107).
Enterprise AP#show system 6-22
System Information
==============================================================
Serial Number :
System Up time : 1 days, 3 hours, 41 minutes, 40 seconds
System Name : Enterprise Wireless AP
System Location :
System Contact : Contact
System Country Code : US - UNITED STATES
MAC Address : 00-13-F7-1C-33-66
MAC Address : 00-13-F7-1C-33-66
Radio G MAC Address : 00-13-F7-1C-33-67
IP Address : 192.168.2.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
VLAN State : DISABLED
Management VLAN ID(AP): 1
IAPP State : ENABLED
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTP Session Timeout : 300 sec(s)
HTTPS Server : ENABLED
HTTPS Server Port : 443
Slot Status : Single band(b/g)
Boot Rom Version : v1.1.1
Software Version : v5.0.0.0
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
DHCP Relay : DISABLED
==============================================================
Enterprise AP#
To Next Page
Loading...
