SMC Networks LEFS25 User Manual

- 9 -
2. Specification
2.1 Slider type LEF Series / Ball screw drive Specification
(1) Step motor (servo 24VDC) Ball screw drive
Note 1) The strokes shown in ( ) are produced upon receipt of order.
Note 2) The speed is dependent on the workload. Check the following “Speed-workload graphs” for the selected model.
Note 3) A reference value for correcting an error in reciprocal operation.
Note 4) Impact resistance: No malfunction occurred when the actuator was tested with a drop tester in both an axial direction and
perpendicular direction to the lead screw. (The test was performed with the actuator in the initial state.)
Vibration resistance: No malfunction occurred in a test ranging between 45 to 2000 Hz, when the actuator was tested in both an axial
direction and a perpendicular direction to the lead screw. (The test was performed with the actuator in the initial state.)
Note 5) The "Power consumption" (including the controller) is for when the actuator is operating.
Note 6) The “Standby power consumption when operating” (including the controller) is for when the actuator is stopped in the set position
during operation.
Note 7) The "Momentary max. power consumption" (including the controller) is for when the actuator is operating.
This value can be used for the selection of the power supply.
Note 8) Only applies to actuators supplied with a lock.
Note 9) For the actuator with lock, please add the power consumption for the lock.
Weight
Model
Stroke(mm) 50 100 150 200 250 300 350 400 450 500
Weight(kg) 0.83 0.90 0.98 1.05 1.13 1.20 1.28 1.35 1.43 1.50
Additional weight for lock(kg)
Model
Stroke(mm) 50 100 150 200 250 300 350 400 450 500 550 600 650 700 750 800
Weight(kg) 1.70 1.84 1.98 2.12 2.26 2.40 2.54 2.68 2.82 2.96 3.10 3.24 3.38 3.52 3.66 3.80
Additional weight for lock(kg)
Model
Stroke(mm) 50 100 150 200 250 300 350 400 450 500 550 600 650 700 750 800 850 900 950 1000
Weight(kg) 3.15 3.35 3.55 3.75 3.95 4.15 4.35 4.55 4.75 4.95 5.15 5.35 5.55 5.75 5.95 6.15 6.35 6.55 6.75 6.95
Additional weight for lock(kg)
LEFS16
0.12
LEFS25
0.26
LEFS32
0.53
14 15 12 25 30 20 45 50
9 10 10 20 20 15 40 45
2 4 0.5 7.5 15 4 10 20
～500 10 to 700 5 to 360 20 to 1100 12 to 750 6 to 400 24 to 1200 16 to 800 8 to 520
501～600 - - 20 to 900 12 to 540 6 to 270 24 to 1200 16 to 800 8 to 400
601～700 - - 20 to 630 12 to 420 6 to 230 24 to 930 16 to 620 8 to 310
701～800 - - 20 to 550 12 to 330 6 to 180 24 to 750 16 to 500 8 to 250
801～900 - - - - - 24 to 610 16 to 410 8 to 200
901～1000 - - - - - 24 to 500 16 to 340 8 to 170
～500 10 to 500 5 to 250 20 to 1000 12 to 500 6 to 250 24 to 1200 16 to 500 8 to 250
501～600 - - 20 to 900 12 to 500 6 to 250 24 to 1200 16 to 500 8 to 250
601～700 - - 20 to 630 12 to 420 6 to 230 24 to 930 16 to 500 8 to 250
701～800 - - 20 to 550 12 to 330 6 to 180 24 to 750 16 to 500 8 to 250
801～900 - - - - - 24 to 610 16 to 410 8 to 200
901～1000 - - - - - 24 to 500 16 to 340 8 to 170
Basic type
High precision type
Basic type
High precision type
10 5 20 12 6 24 16 8
20 39 47 78 157 72 108 216
24 VDC±10%
Guide type
Lock unit
specifications
Power consumption [W]
note9)
22
Note2)
Speed
[mm/s]
Stroke
range
Lost motion[mm]
note3)
Positioning repeeatability [mm]
Note2)
Speed
[mm/s]
Stroke
range
Incremental A/Bphase (800 pulse/rotation)
18
51
44
5
5
LEFS16
123
0.1or less
□28
50 to 800
50 to 1000
LEFS25
LEFS32
□56.4
Non-magnetizing lock
50 to 500
3,000
90 or less(No condensation)
5 to 40
Linear Guide
Ball screw(LEFS□)、Ball screw+Belt（LEFS□L/R）
50 / 20
±0.02
±0.015（Lead H：±0.02）
0.05or less
2.9
Electric specifications
□42
Standby power consumption when operating
[W] note
6)
Max.instantaneous power consumption [W]
note
7)
Step motor(Servo 24V DC)
57
38
16
Model
24 VDC±10%
50
Stroke [mm]
Note1)
Actuation type
Max.acceleration/deceleration [mm/s
2
]
LECP6/LECP1/LECPMJ/JXC91
Controller
type:
LECP6
LECP1
LECPMJ
JXC91
Driver
type
LECPA
lead [mm]
Impact/Vibration resistanc [m/s
2
]
note4)
Operating temperature range [℃]
Operating humidity range [%RH]
Motor size
Holding force [N]
Type
note8)
Rated voltage [V]
Actuator specification
Encoder
Rated voltage [V]
Power consumption [W]
note5)
Motor type
Work load
[kg]
Note2)
Vertical
Horizontal
LECPA
2021-05-2010:32
DW913599

SMC Networks LEFS25 Specifications

General

Brand	SMC Networks
Model	LEFS25
Category	Controller
Language	English