SMC Networks LEFS25 User Manual

- 5 -
1.2 Controller setting software
1. Installation of software
With the controller setting software CD-ROM, install the communication unit software, following the
“Software Installation procedure” (PDF)
2. Startup of software
After turning on the controller power supply, start up the ACT Controller setting soft ware.
Select “Easy Mode” Select “OK”
3. JOG Drive
a. Driving preparation: Servo On → Return to ORIG
Select “Monitor” Select “OK” (1)”SVRE” lighting is confirmed
b. JOG Drive (2) Select “Return to ORIG”
Clicking arrow button→Operation
c. Driving stop: Servo Off
Select “Test” Select “OK”
Select “test”
Caution
If an alarm is generated
(1) When ”ALARM” is generated, release it by selecting (2) “Reset”.
In the case of an alarm code that cannot be released with
“Reset”, turn the power supply OFF and ON again.
Note) For details of alarm codes, refer to the Controller Operation Manual.
※
(1)
(1)
(2)
(2)
End side
Motor side
End side
Motor side
2021-05-2010:32
DW913599

SMC Networks LEFS25 Specifications

General

Brand	SMC Networks
Model	LEFS25
Category	Controller
Language	English