Configuring Your Gateway
99
SMCD3GN2 Wireless Cable Modem User Manual
Figure 55. Warning Message when Restoring Factory Defaults
Using the Reboot Menu to Reboot the Gateway
Using the Reboot menu, you can reset the Gateway and retain all changes that have been
made to the Gateway’s factory default settings. To access the Reboot menu, click Tools in
the menu bar and then click the Reboot submenu in the menu bar. Figure 56 shows an
example of the menu.
Figure 56. Reboot Menu
To reboot the Gateway and retain all changes made to its factory default settings:
1. In the Reboot menu, click Apply. The precautionary message in Figure 57 appears.
2. Click OK to reboot the Gateway or click Cancel to not reboot it. If you clicked OK, the
reboot is complete when the POWER LED stops blinking and you will need to log in to the
Web interface again.
To Next Page
Loading...
