PARAMETER NAME PARAMETER DESCRIPTION
British unit
If parameter is set to 1, values are expressed in British
unit, otherwise in international ones.
Time meter / odometer / weight
of the load on the forks on
display
If parameter value is 0, display shows the hour meter.
If parameter is set to 1, odometer indication appears .
If parameter value is 2, display shows weight on the
forks
High lift switch 1 drive maximum
speed
Max. lift truck speed when the forks are above the1st
critical height
High lift switch 2 drive maximum
speed
Max. lift truck speed when the forks are above the 2nd
critical height
Diameter of drive tyres
This parameter gives drive tyres diameter measure
(expressed in mm)
Limitation temperature
If a motor temperature is above this value, acceleration,
inversion,release ramps and max torque are reduced in
function of temperature value.
Maintenance time inserting
enable
f parameter is set to 1 program service function is
enabled
Starting motors fan temperature
If the motor temperature exceeds this threshold the
motors fans are activated
Maintenance time
If the truck working hours exceed this value the display
signals the maintenance request
BATTERY
PARAMETER NAME PARAMETER DESCRIPTION
Battery reset value
Minimum battery voltage necessary to reset battery
discharged voltage alarm
Discharged battery voltage
If the battery voltage becomes lower than this value
the battery discharged alarm is set
PRELIMINARY VERSION 59
To Next Page
Loading...
