TIMERS
PARAMETER NAME PARAMETER DESCRIPTION
Seat switch delay
Time interval between seat switch opening and drive
and pump motors stopping
Hydro time
Time interval when pump motor works (with hydro
speed) after the end of a command
Chat time
Time delay between last command given to a drive
or pump motor and chat mode signalling
Stop on slope time
If operator stops on slop, after this time interval lift
truck begins to slowly move
SENSORS AND POTENTIOMETERS
PARAMETER NAME PARAMETER DESCRIPTION
Accelerator pedal minimum value Accelerator sensor voltage with pedal released
Accelerator pedal maximum value
Accelerator sensor voltage with pedal completely
pressed
Lift sensor minimum value Lift sensor voltage with lift lever released
Lift sensor middle value
Lift lever potentiometer voltage to which the lifting
becomes proportional to the shift of the lever
Lift sensor maximum value Lift sensor voltage with lift lever completely pressed
Steering sensor minimum value Steering sensor voltage with wheels turned on left
Steering sensor middle value Steering voltage with wheels straight ahead
Steering sensor maximum value Steering sensor voltage with wheels turned on right
Weight of the load on the forks [kg]
This parameter is used to calibrate lift sensor to
calculate the weight of load present on forks
No load pressure [bar · 10]
This parameter is used to calibrate lift sensor to
calculate the weight of load present on forks
Load pressure [bar · 10]
This parameter is used to calibrate lift sensor to
calculate the weight of load present on forks
PRELIMINARY VERSION 60
To Next Page
Loading...
