Smeg A5-8 - Removing the Guide Frames; Cleaning the Door Glazing

Instructions for the user
90
9.5.1 Removing the guide frames (left oven)
Removing the guide frames enables the sides to be cleaned more easily.
To remove the guide frames:
1 Pull the frame towards the top of the oven
to unhook it from its housing A, then slide
it out of the seats B at the back.
2 When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
9.5.2 Removing the guide frames (right oven)
To remove the guide frames:
1 Pull the frame towards the inside of the
oven to unhook it from its housing A, then
slide it out of the seats B at the back.
2 When cleaning is complete, repeat the
above procedures to put the guide frames
back in.
9.6 Cleaning the door glazing
The glass in the door should always be kept thoroughly clean. Use absorbent
kitchen roll; remove stubborn dirt with a damp sponge and an ordinary
detergent.
Do not use abrasive or corrosive detergents to clean the oven's door glass
panels (e.g. powder products, spot-removers and wire sponges).
Do not use rough or abrasive materials or sharp metal scrapers to clean the
oven's glass doors since they may scratch the surface.