Instructions for the user
93
10.EXTRAORDINARY MAINTENANCE
The oven requires periodic minor maintenance or replacement of parts subject
to wear, such as gaskets, light bulbs, etc. Specific instructions for each operation
of this kind are given below.
Before any intervention that requires access to live parts, disconnect the
appliance from the power supply.
If a problem cannot be resolved through ordinary maintenance or in case of
other types of fault, contact your local technical support centre.
10.1 Replacing the light bulb (left oven)
Remove the bulb protector A by turning it
anticlockwise and replace bulb B with a similar
one. Re-fit bulb protector A.
Use only oven bulbs (T 300°C).
10.2 Replacing the light bulb (right oven)
If a light bulb needs to be replaced because it
is worn or burnt out, remove the guide frames;
see “9.5.2 Removing the guide frames (right
oven)”.
Then remove the bulb cover using a tool (e.g. a
screwdriver).
Remove the bulb by unscrewing (filament
bulbs) or pulling it out (halogen bulbs) in the
indicated direction. Replace the bulb with one
of the same type (25W for filament bulbs or
40W for halogen bulbs).
Press the cover down as far as it will go so that it attaches completely to the bulb
support.
To Next Page
Loading...
