9
Instructions for the installer
4. INSTALLATION
4.1 Electrical connection
Make sure the voltage and the cross-section of the power cord match the
specifications indicated on the identification plate positioned on the frame
of the oven door. Do not remove this plate for any reason.
The appliance must be earthed in compliance with electrical system
safety regulations.
If a plug and socket connection is being used, make sure that the plug
and socket are compatible. Avoid use of adapters and shunts as these
could cause overheating and risk of burns.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than 3 mm,
in an easily accessible position close to the appliance.
For operation on 220-240V
∼
: use a
H05RR-F / H05V2V2-F type three-core
cable (3 x 1.5 mm
2
).
The cable end to be connected to the
appliance must be provided with a ground
wire (yellow-green) at least 20 mm longer.
The manufacturer declines all responsibility for damage to persons or
things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
To Next Page
Loading...
Need help?
General
