Instructions for the User
56
9. EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts
subject to wear such as gaskets, bulbs, etc. The following instructions describe
how to carry out these minor maintenance operations.
Before any intervention that requires access to live parts, disconnect the
power supply of the appliance.
9.1 Replacing the light bulb
If a light bulb needs to be replaced
because it is worn or burnt out, remove
the guide frames; see “8.5.1 Removing
guide frames”.
Then remove the bulb cover using a tool
(e.g. a screwdriver).
Remove the bulb by sliding it out as
shown.
On some models only: the bulbs are
halogen bulbs, so do not touch them
directly with your fingers, wrap them in
an insulating material.
Replace the bulb with one of the same
type (40W). Replace the cover correctly,
so that the moulded part of the glass is
facing the door.
Press the cover down as far as it will go so that it attaches completely to the bulb
support.
To Next Page
Loading...
Need help?
General
