Do not cut the inlet hose (see fig. 10). If the hose is cut, the dishwasher will
not work, water will leak and you may be injured. If the hose is too long,
wind it up tidily and place it behind the appliance. The cable harness and
electrical components must not come into contact with the hydraulic
system and the water inlet and drain hoses.
When connecting the dishwasher drain hose to the sink make sure that the
hose is not bent (ref. A fig. 11) in order to prevent cracks or breakages that
could damage it.
INSTALLATION INSTRUCTION
Fig. 10
Fig. 11
EN
15
To Next Page
Loading...
Need help?
General
