If a gap is created between the control panel and the door panel (ref. A
Fig.30), use the supplied strips (ref. B Fig.30) to fill it.
The number of strips depends on the size of the gap.
Position the strips between the control panel and the door panel of the
dishwasher (ref. A Fig. 31) and fix them from under the control panel with
the supplied screws (ref. B Fig. 31 ) using a screwdriver. Adjust the strips
until a suitable compromise is reached.
INSTALLATION INSTRUCTION
Fig.30
Fig.31
EN
28
To Next Page
Loading...
Need help?
General
