Smith SPS8 - Cutter Selection

SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
1/2009
7
SPS8
CUTTER SELECTION
CARBIDE or STEEL?
Whenconguringyourcutterdrumforremoval,oneofthemost
important questions to ask is: “Which cutter type do I use, carbide or steel?”
Tungstencarbidewillproduceasmoothersurfacenishifsetupproperlyand
Carbide also lasts longer. Professionals use carbide cutters to save time and money.
Therearevetypesofcuttersthatyoucanuseonthismachine
(RefertoourCutterDatasheetforspecicsizesandorderinginformation):
1 Beam steel cutters for
gentle scarifying.
HS1000™
2 Star steel cutters for light
to medium scarifying.
HS1008™
3    3MBrandRoto-peenshotapsasan
alternative to steel shot blasting
25022
4 Tungsten carbide spiked cutters to remove
coatings, as well as clean, plane, mill, scarify,
CF2616™ CF2618™ roughen, smooth, groove, grind, eradicate or
remove on concrete or asphalt.
CF2516™ CF2515™
5 Special carbide scrapers designed for
asphalt- removing preform tapes,
      thermoplastics,orthicklmcoatings.
CM2535™ CM2150™
NOTE: Only SMITH Brand Ultra-Premium Tungsten carbide is the
most cost-effective cutting tool and lasts up to 25x longer than
conventional cutters while removing 5x faster on asphalt or concrete.