5
Service
MAINTENANCE
Engine Oil
Change and add oil according to chart below based on air temperature at the time of operation. Do not
recommended oils. Do not mix oil with gasoline.
1. Use SAE 10W-40 API Service SJ or higher motor oil.
4. After changing oil, run the machine for a few minutes. Check oil level and for leaks.
5.
-
taminants. Check and service more frequently when operating in extremely cold, hot or dusty conditions.
-
lem exists.
9. In extreme temperatures you can use straight weight oil. We recommend SAE 30W API Service SG
when hot (above 90°F (33°C)) and SAE 10W API Service SJ or higher when cold (below 32°F (0°C)
ambient temperature. Use either motor oil or hydraulic oil, but do not mix.
10. Oil being added to the system must be the same as what is already in the tank.
as to which type you put in.
Tire Pressure
Caution must be used when inating a low tire to recommended pressure.
Over inating can cause tires to explode. Front tires should be 20 psi (1.4bar)
and rear tires should be 18 psi (1.3 bar). Improper ination will reduce tire life
considerably.
Wheel Mounting Procedure
2. Block wheel on opposite corner.
3. Loosen nuts slightly on wheel to be removed.
4. Jack up machine being careful not to damage underside of machine.
5. Place wheel on hub lining up bolt holes.
hours thereafter.
7. Lower machine to ground and remove blocks and jack.
To Next Page
Loading...
