SMP 908 - General Settings - Frequency and Signaling; Frequency Channel Step Setup; DTMF, ANI, 2 Tone, 5 Tone Signaling

18
Press
2.
/ key to choose No.01 menu, LCD displays
”STP--125”
Turn selector knob to select the desired frequency channel step.
3.
Channel step: 2.5K(VHF),5K,6.25K,8.33K,10K,12.5K,20K,25K,30K
and 50K, total 9 kinds.
Press
4.
key to conrm and exit
Press and hold
1.
key for over 2s to
enter general setting menu.
Press and hold
1.
key for over 2s to enter general setting menu.
Press
2.
or to select the desired function option.
Turn selector knob to select the desired setup.
3.
Press
4.
to conrm and exit.
Meanwhile,if you want to edit channel name or start up menu,press
or to move forward or backward,Press to store and exit.
Only in frequency (VFO) mode, this function is valid. Turn selector
knob to select frequency or frequency scanning which is restricted by
frequency step size.
8
General Setting
01 Frequency Channel Step Setup
This function is auto-hidden in channel mode.
02 DTMF, DTMF ANI, 2Tone or 5Tone Signaling
DTMF/5Tone/2Tone signalling function as similarily as CTCSS/DCS.
Without receiving correspondent tone signalling, the speaker will remain
mute. DTMF and 5Tone signalling can be applied for other advanced
features such as ANI, PTT ID, group call, remotely stun,remotely kill,
waken,...etc. The signalling edition must be done through programming
software. Please refer to the HELP option in the programming software
to know how to operate these features.
Press and hold
1.
key for over 2s to
enter into general setting menu.
Press
2.
/ t o c h o o s e N o 2
menu,LCD displays"T-OFF" .
Turn selector knob to
3.
select the desired
setup.
"DTMF”: the channel will be mute by a DTMF signal. The

speaker won’t be open until receiving a correspondent DTMF
signal. Hold "PTT" then press [UP] or press
directly to
transmit the pre-stored DTMF signaling.
In Profession transceiver mode,the functions from No.1 to No.17
will be auto-hidden.
In DTMF signaling mode,press for 2s until LCD displays
"AN---",turn selector knob to select desired digit(the other party
ID).In this mode,press
to conrm exist digit and move cursor
to next,press
to forward cursor.After editing,press key
to operate ANI call.
"2TONE": the channel will be mute

by a 2-Tone signal. The speaker
won’t be open un til receiving a
correspondent 2-Tone signal.Hold
“PTT” then press [UP] or press
directly to transmit the pre-stored
2-Tone signaling.
"5Tone": the channel will be mute

by a 5-Tone signal. The Speaker won’t be open until receiving
a correspondent 5-Tone signal. hold “PTT” then press [UP] or