SMP 908 - Programming Software Setup; Software Installation and Driver Setup; Connecting and Starting the Software

32
11
Programming Software Installing and Starting (in windows XP system)
Double click ”PS908 setup.exe“, then follow the installing instruction.
Install USB Cable Driver Programme
Click start menu in computer, under “ALL PROGRAMS” menu,
1.
choose and click “USB To Com port” in PS908 program, install “USB
To Com port” driver by indication.
Connect the optional
2.
30Q183301 USB Programming cable to USB
port in PC with transceiver.
Double click shortcut "SMP908" or click "SMP908" under "ALL
3.
PROGRAMS" menu. click "OK" to start programming software.
Note:
Even in same computer,the selective COM Port is different
when USB cable connects with different USB port.
Switch on transceiver before writing frequency.You had better not
switch on or off the power supply of transceiver when it is connected
with computer, otherwise, it will make transceiver unable to read or write
frequency. In this case, you have to turn off programming software,
pull out USB cable.then reinsert USB cable and open software, then
rechoose COM Port, it will turn into normal operation. Therefore, please
connect transceiver with computer after switching on the transceiver.
Don't restart transceiver power when it is connected with computer.