134
Scope Multimeter Operations Operations
Unit Setup
The units of measurement can be changed between US standard or metric units of measure for
pressure and vacuum readings. Selecting Units opens the Setup dialog box (Figure 9-16).
Figure 9-16 Sample Setup Units dialog box
Snapshot
The Snapshot tab of the Setup dialog box opens a window that allows you to select how much
data is captured after a snapshot is triggered (Figure 9-17).
Selections range from ten to ninety percent in increments of ten, the current setting is highlighted.
Select a icon, then select OK to close the dialog box.
Figure 9-17 Sample Snapshot dialog box
Refer to Trigger Controls on page 130 for information on how to setup a trigger.
To Next Page
Loading...
