38
|
Snapmaker Enclosure
|
39
How to Use
When the machine is under working condition, you can swipe left on the Touchscreen to
control the LED Strips and the Exhaust Fan.
To change the toolheads and the platforms when the machine is enclosed, follow the
steps as follow. The H2.5 screwdriver bit will be used.
1. Open the doors.
2. Enter Home -> Controls -> Jog Mode to move the toolhead and platform to proper places that are convenient
for detaching.
3.2 Change Machine Functions
Guides & Pictures / Snapmaker
3. Switch off the machine, unplug the toolhead cable, then detach the toolhead and platform.
To avoid injury, make sure to remove the CNC bit before detaching the CNC module from
the machine.
4. Attach the needed toolhead and platform, then connect the cable to the controller.
To Next Page
Loading...
