Need help?Do you have a question about the Snapmaker J1s and is the answer not in the manual?
General| Nozzle Diameter | 0.4 mm (default) |
|---|---|
| Maximum Nozzle Temperature | 300°C |
| Maximum Bed Temperature | 100°C |
| Print Speed | Up to 350 mm/s |
| Layer Resolution | 0.05 - 0.3 mm |
| Filament Diameter | 1.75 mm |
| Printing Technology | FDM (Fused Deposition Modeling) |
| Connectivity | Wi-Fi, USB |
| Supported Materials | PLA, ABS, PETG, PA, PC |
| Dual Extrusion | Yes |
| Touchscreen | Yes |
| Power Requirements | 100-240V AC, 50/60Hz |
To Next Page
