Need help?Do you have a question about the Snapmaker A150 and is the answer not in the manual?
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Filament Compatibility | PLA, ABS, PETG, TPU |
| Nozzle Temperature | up to 250 °C |
| Heated Bed Temperature | up to 100 °C |
| Filament Diameter | 1.75 mm |
| Software | Snapmaker Luban |
| Layer Resolution | 0.1 - 0.3 mm |
| Print Speed | 10 - 100 mm/s |
| Connectivity | USB |
| Printing Technology | FDM (Fused Deposition Modeling) |
| Power Requirements | 100-240V AC |
To Next Page
