Need help?Do you have a question about the Snapmaker Dual Extrusion 3D Printing Module and is the answer not in the manual?
General| Extruder Type | Dual Extrusion |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Max Extrusion Temperature | 300°C |
| Layer Height | 0.05 - 0.3 mm |
| Heated Bed Temperature | 100°C |
| Supported Filament Diameter | 1.75 mm |
| Maximum Extrusion Temperature | 300°C |
| Compatible Filaments | PLA, ABS, PETG, TPU |
| Compatible Printers | Snapmaker 2.0 |
| Connectivity | USB, Wi-Fi |
To Next Page
