Snapmaker A150 - Clamp the Material; CNC Carving Workflow

User Manual |
147
CNC Carving - 04 How to CNC Carve
04 How to CNC Carve
4.1 CNC Carving Workflow
Pre-check
⇩
Clamp the Material
⇩
Attach the CNC Bit
⇩
Prepare the G-code File
⇩
Transfer the G-code File
⇩
Set the Work Origin and Start Carving
⇩
Clean the Finished Work
Before caving, you should thoroughly check the CNC carver and bit (see 6.2 Before You Carve).
4.2 Clamp the Material
Use Provided Clamp Sets
(1) Peel off the masking papers from the acrylic sheet.