Snapmaker A150 - Safety Measures

User Manual |
8
Safety Guidelines - Labels on Your Snapmaker
Safety Measures
General Safety Information
Read the entire manual before use.
This machine should only be used by trained operators aged 18 and above.
This machine should be used exclusively for recreational purposes.
Do not leave the machine unattended while it is on.
Do not touch the moving parts while the machine is in operation.
Do not operate the machine while tired or under the influence of drugs, alcohol, or medication.
Do not let children use the machine without the supervision and assistance of an adult.
Always operate this machine indoors on a solid horizontal table or workbench.
Do not expose this machine to rain or wet conditions.
Always cut the power supply before maintenance or modifications.
In all EU member states, the operation of 5150-5250 MHz is restricted to indoor use only.
3D Printing Safety
Do not touch the nozzle, hot end, Print Sheet, Heated Bed, and uncured filament when the 3D printer is heating or
printing.
Turn off the 3D printer immediately if any of the following occurs:
- The 3D printer is on re which persists after it is turned off.
- The 3D printer stops unexpectedly.
- Any damage is incurred to the interior components of the 3D printer.
- Any unusual light or sound comes from the 3D printer which has never occurred previously.
Laser Safety
The small percentage of the population (0.01%) that have blue-yellow color blindness (tritanopia) may struggle to see
the laser lights and may not realize that the laser engraving and cutting machine is turned on. Tritanopic users must
therefore be particularly careful.
Operate the machine wearing the Laser Safety Goggles and other protective equipment such as a mask or using the
Enclosure.
The Laser Module is a class 4 laser product. You should operate the Laser Module only if you have sufficient knowledge of
the physical properties of laser radiation, Laser Hazard Classes and associated health implications, and safety measures.
Never expose yourself to the laser beam. Proper use and care of the Laser Module are essential to safe operation.
Keep children and bystanders away while operating this machine.
Operate the laser engraving and cutting machine in a well-ventilated place or with an air purifier.
Remove any reflective material from the work area underneath the Laser Module, as it can cause scattered radiation.
Turn off the machine immediately if any of the following occurs:
- Open ames appear.
- The machine stops unexpectedly.
- Any damage is incurred to the interior components of the laser engraving and cutting machine.
- Any unusual light or sound comes from the machine which has never occurred previously.
Safety Guidelines - Safety MeasuresSafety Guidelines - Safety Measures