User Manual |
132
Laser Engraving and Cutting - 06 Troubleshooting
Replace admin with your username.
6.3 Laser Is Discontinuous or Weak
The Laser Module emits weak light and does not engrave at its full power, and therefore the module can't nish Auto
Focus.
Possible Causes
• The Enclosure's door is open during Auto Focus.
• The Laser Module is too high during Auto Focus.
• The Laser Module is broken.
Solutions
• Either close the Enclosure's doors or go to Enclosure > Settings to disable the Door Detection feature.
To Next Page
Loading...
