Snapmaker A150 - Laser Engraving and Cutting Workflows; Non-Transparent Acrylic (2.6 MM)

User Manual |
78
Laser Engraving and Cutting - 02 Material Library
2.10 Non-transparent Acrylic (2.6 mm)
Work Parameters
Cutting
Work Speed 40 mm/min
Passes 4
Pass Depth 0.6 mm
Power 100%
03 How to Laser Engrave and Cut
3.1 Laser Engraving and Cutting Workflows
Snapmaker provides you with the following two methods to help you position the laser working area:
• Use Camera Capture
• Set Work Origin
If you use the method of camera capture, you must connect your machine to Luban, and use Luban for the
subsequent operations. If you set the work origin, you can start laser engraving and cutting by using Luban or the
Touchscreen. Depending on the positioning methods and operating consoles you choose, the workflows can be
different. This section provides the three workflows you can follow to start laser engraving and cutting.
The engraving and cutting effects depend on the material you choose and the parameters you
congure, regardless of which workflow you opt for.