Snapmaker A150 - Firmware

User Manual |
14
Safety Guidelines - Touchscreen
Firmware
How to Update
Before use, update the Firmware to the latest version. For Touchscreen with the firmware of V1.9.0 or later, you can
update via Wi-Fi or USB flash drive. For firmware previous to V1.9.0, update only via USB flash drive.
: Turn on the machine > Connect your machine to a Wi-Fi network > Swipe left on the Touchscreen > Tap Settings >
Firmware Update > Check for Updates > Update Now > Complete.
: Download our firmware from snapmaker.com/product/snapmaker-2/downloads > Insert the USB flash drive into
the Controller > Turn on the machine > Swipe left on the Touchscreen > Tap Files > USB > Tap the firmware file to
update.
Should you need to update the Touchscreen firmware, Controller firmware, or the firmware of other
modules and addons separately, download them from our website or forum to your USB flash drive,
and update via Touchscreen.
Version Requirements
Should you use the 3D printer together with addons like the Enclosure, Rotary Module, Emergency Stop Button, or Air
Purifier, update the firmware to the required version:
- Enclosure: V1.10.0 or later
- Rotary Module: V1.12.0 or later
- Emergency Stop Button: V1.12.0 or later
- Air Purier: V1.13.1 or later
To check the firmware version, tap Settings > About Machine.
Before using the Emergency Stop Button, you should update the firmware to version 1.12.0 or later as
required.
Touchscreen - Firmware