Snapmaker A150 - Before You Engrave and Cut; Maintenance Schedule

User Manual |
121
Laser Engraving and Cutting - 05 Maintenance
05 Maintenance
5.1 Maintenance Schedule
This maintenance schedule is for reference only. Should you use the laser engraving and cutting machine more
frequently, adjust your schedule according to your usage frequency. Before maintenance, check Snapmaker’s Limited
Warranty so as not to void your warranty.
Turn off the power supply before maintenance.
Before You Engrave and Cut
Task See
Check the Cables 5.2.1
Check the Support Platform 5.2.2
Check the Laser Engraving and Cutting Platform 5.2.3
Check the Built-in Fan 5.2.4
Check the Camera and the Camera Light 5.2.5
Every Month
Task See
Clean the Linear Modules 5.3.1
Clean the Side Covers 5.3.2
Clean the Exhaust System 5.3.3
Every Three Months
Task See
Update the Firmware and Software 5.4
5.2 Before You Engrave and Cut
5.2.1 Check the Cables
Check if every cable is plugged into the right socket, in the right direction.
• Into the Controller (A150)