Socket CHS Series 7 - Command Barcodes for CHS 7 E, 7 M or 7 P in SPP Mode

110
Command Barcodes for CHS 7E, 7M or 7P in SPP Mode
These command barcodes can be scanned with a CHS in SPP mode. Many will not work for a CHS in HID mode. If you do
not know which mode your CHS is in, you can scan the command barcode for SPP Mode to make sure the CHS is in SPP
mode.
You can also use the SocketScan 10 Scanner Settings utility to modify some beep, vibrate, prefix/suffix. For
instructions, please refer to the chapter for your OS.
To enable/disable symbologies, please use SocketScan 10 Scanner Settings. Advanced users can also use the
Symbology barcodes in the HID section (previous 3 pages).
The CHS can only be paired with one device at a time. To use the CHS with a different device, see Appendix G
for unpairing instructions.
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Bluetooth Connection Settings
SPP Mode
Changes the CHS to Serial Port Profile (SPP) mode.
Required for BlackBerry, optional for Windows.
HID Mode (default)
Configures the CHS to Human Interface Device (HID) mode. The CHS will be
discoverable as a Keyboard to other Bluetooth devices.
Required for Apple iOS, Mac OS, Nokia E71.
Acceptor (default)
Configures the CHS to accept a Bluetooth connection puts the CHS in discoverable
mode.
Initiator
Configures the CHS to initiate a connection to a computer / device with the Bluetooth
Device Address specified in the barcode.
The barcode must be formatted in Code 128 and contain the data
#FNIaabbccddeeff# such that aabbccddeeff is the Bluetooth Device Address of
the computer/device you want to connect to the CHS.
Required for Windows when using SPP mode.
You must create a custom barcode for each
computer / device that you want to connect to
the CHS.
Use barcode generating software or website
(e.g., http://barcode.tec-it.com
))
Factory Defaults
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS will power off af
ter
scanning this barcode.