Socket CHS Series 7 - Page 111

APPENDIX F: COMMAND BARCODES FOR CHS 7E, 7M, 7P 111
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Automatic Reconnection Settings
ENABLE Automatic Reconnection from CHS (default)
Configures the CHS to automatically initiate a connection to the last paired computer /
device after the CHS is powered on.
IMPORTANT! After scanning this command barcode, power off and power on the CHS
to make sure it is configured properly.
DISABLE Automatic Reconnection from CHS
Configures the CHS to wait for a computer / device to initiate a Bluetooth connection
after the CHS Is powered on.
IMPORTANT! After scanning this command barcode, power off and power on the CHS
to make sure it is configured properly.
Data Editing – Suffix
Data As Is (default)
Configures the CHS to
return only the decoded
data (i.e., prefix and suffix
are not sent).
Suffix – Carriage Return
Configures the CHS to add
a carriage return at the
end of decoded data.
Suffix – Tab
Configures the CHS to add
a tab at the end of
decoded data.
Suffix – Carriage Return
& Line Feed
Configures the CHS to add
a carriage return and line
feed at the end of decoded
data.