CHAPTER 5: SETUP FOR APPLE 57
After decoding the barcode and sending it to the computer, by default the CHS will
beep once, the LED will flash green, and the aiming beam will turn off. The CHS 7Ci
and 7P will also vibrate to indicate that the barcode is decoded. You can use the
Command Barcodes
to modify the beep / LED / vibrate settings.
By default, a carriage return is applied after scanned barcode data is entered. To
disable the automatic carriage return, you can use the Command Barcodes
(use the
Data Editing barcode for disabling suffixes).
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds, until
the CHS beeps twice (high-low) and the blue LED turns off.
After the iPad disconnects from the CHS, the soft keyboard will automatically reappear
within a few seconds.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it paired
and connected to. Make sure your computer is in range with Bluetooth enabled.
If the CHS is connected to your computer and gets disconnected, it will try to reconnect.
Make sure the computer is on and in range. If the CHS cannot reconnect after several
attempts, it will emit a long beep. Press the trigger button to restart the reconnection
process.
The CHS can only be paired with one device at a time. To use the CHS with a
different device, see Appendix G
for unpairing instructions.
Simultaneous Scanning and Soft Keyboard Support:
Revisions B and later of the CHS 7E/7M/7P and all revisions of the 7C/7Ci support
simultaneous use of the barcode scanner and the onscreen keyboard while entering data into
an application. This feature is enabled by default and can be modified by scanning a special
command barcode.
1. Connect the CHS to your Apple device.
2. Open your application and place the cursor where you want to enter data.
3. You can begin scanning barcodes. To open or close the onscreen keyboard, quickly double-
press the CHS power button (like double-clicking a mouse).
After you double-press the power button, the CHS will beep to indicate that the
onscreen keyboard was enabled / disabled.
Watch a video: http://www.youtube.com/watch?v=VhtttoC6ROs
To Next Page
Loading...
