SoClean 3

Plug the Power Supply
into an electrical outlet
or power strip.
Plug the Power Supply
into the back of your
SoClean 3 as shown.
NOTE: Your SoClean 3 does not have a power switch to turn the device
on/o. When initially connected to power, the lights on your SoClean 3
will flash a pattern that you may not see if you are not looking at the
device immediately after it is connected to power. The SoClean 3 enters
a low-power “sleep” mode when not in use and fully powers when you
press any of the buttons on the Control Panel.
NOTE: The Filter Issue icon is
illuminated and the Hose Not
Detected icon is flashing on
your Control Panel because the
Filter is not yet installed and the
sleep equipment mask/hose has
not been placed into the
SoClean 3 with the Lid closed.
Power Supply
S E TT I NG UP Y O U R S O C L E A N 3
Locate your Power Supply
in the Welcome Kit as shown.
Remove the Power Supply
from the box.
A Power Supply is provided to safely power your SoClean 3. You will
need access to an electrical outlet near your SoClean 3 to power your
SoClean 3 in a well ventilated room.
POWERING YOUR SOCLEAN 3
Locate an electrical outlet near your SoClean 3 setup.
NOTE: It is okay to plug into a power strip, if needed.
S E TT I NG UP Y O U R S O C L E A N 3
WARNING: Avoid a tripping hazard.
B
C
A
Power
Supply
D
At this point in your SoClean 3 setup, your
Control Panel should appear as shown.
1
DO NOT place the power cord inside the device chamber.
The Lid will not open unless the device is powered.
20 21